Toote tegelik värvus võib erineda piltidel kujutatavast ning pildid on
illustratiivsed.
PFERD SPV 36-6 S6 Replacement spindle
PFERD SPV 36-6 S6, Replacement spindle, 20000 RPM, Black, 5.8 cm
Read more...
Read more...
Product Information
| Information | |
|---|---|
| Manufacturer | PFERD |
| Product code | 264198232 |
| EAN | 04007220061411 |
| Manufacturer part number | 87100069 |
Product Description
With drive spindle extensions, shanks of grinding and milling tools can be extended. They allow access to difficult-to-reach areas. The extensions are clamped into the collet of the machine (air- or electric-powered) or into the flexible shaft handpiece.
Drive spindle extensions are a cost effective alternative to special made-to-order burrs and mounted points with long shanks.
Safety notes:
Caution! When using spindle extensions, please observe the valid safety regulations and the accident prevention regulations.
When working with long shank lengths, it is vital that the tool is inserted into the workpiece (e.g. bores, pipes, ducts or keyways) before the drive system is switched on. The extension must not run freely with the tool outside the workpiece.
In unfavourable conditions, the extension with the tool clamped in it may buckle.
If this rule is not observed, there is an increased risk of accidents!
The extensions are only intended for manual use
Clamping of a second extension or of tools with excessively long shanks is not permitted.
Drive spindle extensions are a cost effective alternative to special made-to-order burrs and mounted points with long shanks.
Safety notes:
Caution! When using spindle extensions, please observe the valid safety regulations and the accident prevention regulations.
When working with long shank lengths, it is vital that the tool is inserted into the workpiece (e.g. bores, pipes, ducts or keyways) before the drive system is switched on. The extension must not run freely with the tool outside the workpiece.
In unfavourable conditions, the extension with the tool clamped in it may buckle.
If this rule is not observed, there is an increased risk of accidents!
The extensions are only intended for manual use
Clamping of a second extension or of tools with excessively long shanks is not permitted.